Technical Specifications
of EcoServer

The media server that needs only 8 Watts.  It is small and economic.  Click here to download data sheet of EcoServer.


EcoServer Features

  • PowerPC 440EPx Processor 667MHz
  • Performance: 2.0 DMIPS/MHz (1,334 DMIPS @ 667 MHz peak)
  • Hardware support for IEEE 754 floating-point
  • High performance hardware IPSec/SSL acceleration
  • 1GB DDR2 RAM with ECC installed
  • Up to 2GB of memory capacity
  • Two 10/100/1000 Ethernet copper (RJ-45) or fiber (SFP) ports
  • CompactFLASH type II socket supports CF card and Microdrive
  • 8W total power consumption
  • Excellent cooling design (no fans)
  • 1U rack mount server chassis
  • One PCI slot in 1U, max. 4 slots in higher enclosure
  • Ubuntu 8.04 LTS Linux installation available on CompactFLASH or Microdrive
  • One Year Limited Warranty


EcoServer Specifications



PowerPC 440EPx Processor 667MHz


1 x 240 pins DDR2 DIMM socket with a maximum of 2GB. (1GB unbuffered DDR2 with ECC installed)

Error Detection

single-bit error correction and double-bit error detection

On-board FLASH

One 16MB read-only with permanent U-boot, one 64MB upgradeable with U-boot and Linux kernel

On-Board I/O

Real Time Clock, Temperature Sensor, User EEPROM, Audible Alarm

USB 2.0 host ports

Three high speed ports, one internal, 2 external accessible from the back

USB 2.0 device port

One high speed device port accessible from the back

SIM card support

OmniKey (ASSA ABLOY ITG) AT83C230K reader

Mass storage

CompactFLASH type II socket on-board



Two ports - Broadcom BCM5461S 10/100/1000Mbps Ethernet PHY chips, MACs integrated with processor


Each of the two ports has copper (RJ45) and fiber (SFP) media interface


PCI Slots

1 available PCI slot (Requires PCI riser card - not included)

Local bus expansion

32 bit data, 24 bit address bus, I2C available through 120 pin high density edge connector


Hardware monitor

ATMega microcontroller monitors all power supplies and total supply current

Firmware updates

Firmware in upgradeable FLASH may be restored or updated after reset button is held for 10 sec. Console port manages the process


U-Boot commands, optional custom modules

Boot loader

U-Boot, version 1.3.3 in permanent FLASH. Boot from TFTP server optional.

Linux kernel

Version 2.6.25 or higher in upgradeable FLASH

Front Panel

Buttons and ports

Shutdown button
Reset button (recessed)
Location button (Blue LED)
USB 2.0 device port (console)
USB 2.0 host port



Back Panel

Buttons and ports

Location switch (Blue LED)
2 x USB 2.0 high speed host ports
1 x USB 2.0 high speed device port
2 x SFP cage (Ethernet 0 and 1)
2 x RJ-45 (Ethernet 0 and 1)

Power receptacle

Single (optional dual) IEC-320 C14 AC with fuse


Power Supply

25 watts power supply  (110V/220V Auto-switch)

Power Consumption

8 Watts

x H x D)

483mm x 43.7mm x 394mm  (19”x 1.72” x 15.5”)

Operating Temperature

5 to 60 degrees C (41 to 140 degrees F)


9 lb


12 Months (Parts & Labor)